PrintDry Vacuum Sealed Filament Container: Package of 5

Testing

The vacuum filament container has been tested with a 750g filament spool inside for 30 days. The graph below shows the changes of the relative humidity (grey line) inside the container and the ambient humidity (red line) as the storage time increases. Five pouches of 15g desiccant are included in the container.

How to use

Our new vacuum sealed containers are super easy to use.

1) Place your filament spool inside the container with some desiccant pouches, put on the lid and align the tabs of the lid and the container, engage the 4 strong clamps.

2) Take the hand plunger and line up the bottom of the hand plunger with the center vacuum valve on the container lid. Pressing down gently on the hand plunger, simply lift the plunger handle slowly until it reaches the top of the pump, and then push down on the plunger until it reaches the bottom of the pump. Repeat this up and down motion for 15-20 time for the polycarbonate containers or 10-15 for the polypropylene containers.

3) To release the vacuum seal, place your index finger on the outside rim of the valve, and press it towards the center.

*Recommended 15-20 pumps for the polycarbonate containers, 10-15 for the polypropylene containers. Too many pumps may cause buckling.

*Release the vacuum and reapply at least once a month to prevent container base from buckling.