Print Parameters - COEXNylex Unfilled Nylon

COEXNylex Unfilled Nylon print settings

Print COEXNylex Unfilled Nylon with a 245–295°C nozzle, an 85–110°C bed and an enclosure, with the part-cooling fan not recommended, and dry it at 80°C for 8–12 hours.

These are COEX 3D's recommended starting settings, made to match the COEX 3D filament settings tables for every filament we make in Green Bay, Wisconsin. Treat each value as a starting point and adjust it for your printer.

1. Material notes

• Keep filament sealed and dry: nylon absorbs moisture from the air
• Dry an opened spool at 80°C for 8–12 hours
• An enclosure is required

2. Temperature settings

Nozzle temperature: 245–295°C

Bed temperature: 85–110°C

• Bed adhesion: use WELD3D or a PVA-based glue stick (e.g., Elmer's)

3. Cooling settings

Cooling configuration:

• Part cooling fan: not recommended

Please note: These printing parameters are initial recommendations based on our experience. They may need adjustment for your specific 3D printer, environmental conditions and the geometry of the part you are printing. Use them as a starting point and fine-tune them for your needs.